How to hook a rug

Hooking rug is an easy skill to learn. As a technique of warming freezing sodden floors, early people tied their old clothing to burlap bags. It’s a naturally friendly craft that repurposes discarded clothes and fabric scraps. It takes no energy sources other than your own hands and is a delightfully contemplative craft that you can accomplish

Make your design on a weaving casing or a sewing band. It should be tight and level like a drum. Keep your burlap firm on your edge as you hook to make the process much easier.

Your wool may be cut into 1/4-1/2-inch strips. A basic wool cutting technique is to take an eight by four inch square of wool fabric, fold it accordion style, and cut it into strips.

Hold a piece of wool beneath your design. Take your hook and hold it like a pencil. Insert the hook through a burlap gap, fold the wool over the hook on the underside of the burlap, and draw the wool finish up through the gap.

Continue with a comparable piece of wool, drawing it up to the top side of your sample circle by circle.

Begin by drawing anything near to the focal point of your design.

Continue hooking in the third or fourth gap, depending on the breadth and thickness of the wool. When your strip is finished, draw the end to the top side of your example and clasp the end so it is an even height with your circles.

Hooking in straight or curved lines is possible.

Always cut your wool and begin over, rather than conveying a shade over the back of your tangle, as this will make your rug huge, chaotic, and simple to pull out.

Continue hooking by drawing out and filling in all of the areas of your floor covering. If you hook too tightly, your rug will not lie level. The squeezing of the circles together keeps the circles from falling out, but if you pack it too tightly, your mat will twist up.

There are several ways for finishing the edges of a rug. Hand stitch dark cotton twill tape over the outside corners of the rug. Attach it directly to the twill tape, or sew it on after the rug has been hooked. When your rug is done, insert two inches of extra burlap into the twill tape and hand stitch it down the back of your rug. If the rug is going up against a wall, you may overlap the excess burlap around the back of the rug and seal it up. With a damp fabric and a hot iron, press the rug.

This is known as obstructing the rug, and it aids in giving it a complete patina and leveling out the circles.

When hooking, do everything it takes not to proceed from left to right, but rather cover a large portion of the rug region in case you run out of wool. If you do this, you may always add more wool in a slightly different shade to finish the rug. It may even improve the roughness of your design.

Hooking rug is meant to be a fun distraction. To avoid painful shoulders or hands, make sure you’re sitting in a comfortable position with your body flexible.

Leave a Reply

Your email address will not be published.